Power On/Off; Turning On The Power; Turning Off The Power - Hitachi CP-X467 Operating Manual

Power on/off

Power on/off

Turning on the power

1.
Make sure that the power cord is firmly and correctly
connected to the projector and the outlet.
2.
Remove the lens cover, and set the power switch to
ON position (marked " I ").
The POWER indicator will light up in steady orange
(74). Then wait several seconds because the
buttons may not function for these several seconds.
3.
Press STANDBY/ON button on the projector or the
remote control.
The projection lamp will light up and POWER indicator
will begin blinking in green. When the power is
completely on, the indicator will stop blinking and light
in steady green (74).
To display the picture, select an input signal according to the
section "Selecting an input signal" (17).

Turning off the power

1.
Press the STANDBY/ON button on the projector or the remote control. The message
"Power off?" will appear on the screen for about 5 seconds.
2.
Press the STANDBY/ON button again while the message appears.
The projector lamp will go off, and the POWER indicator will begin blinking in orange.
Then POWER indicator will stop blinking and light in steady orange when the lamp
cooling is complete (74).
3.
Make sure that POWER indicator lights in steady orange, and set the
power switch to OFF position (marked "O").
POWER indicator will go off. Attach the lens cover.
Do not turn the projector on for about 10 minutes or more after turning it off.
Turning the projector on again too soon could shorten the lifetime of some
consumable parts of the projector.
WARNING
not look into the lens of the projector or look inside of the projector through any
of the projector's openings.
►Do not touch around the lamp cover and the exhaust vents during use or just
after use, since it is too hot.
NOTE
• Turn the power on/off in right order. Please power on the projector
prior to the connected devices.
• When the AUTO ON of the OPTION menu is set to the TURN ON, and the power
was turned off by the power switch last time, turning the power switch on makes
the projection lamp light on without pressing the STANDBY/ON button
• Use the shutdown switch
normal procedure.
16
►A strong light is emitted when the projector's power is on. Do
(75)
only when the projector is not turned off by
STANDBY/ON button
POWER indicator
Power switch
Power switch
.
(44)
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH
BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
POSITION MENU
ENTER
RESET
ESC
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
KEYSTONE
MY BUTTON MUTE
1 2
POSITION MENU
ENTER
ESC RESET