Hitachi CP-X467 Operating Manual page 43

SCREEN menu (continued)
Item
SOURCE NAME
TEMPLATE
Each input port for this projector can have a name applied to it.
(1) Use the ▲/▼ buttons on the SCREEN menu to select SOURCE
NAME and press the ► button.
The SOURCE NAME menu will be displayed.
(2) Use the ▲/▼ buttons on the SOURCE
NAME menu to select the port to be
named and press the ► button. Right
side of the menu is blank until a name is
specified.
The SOURCE NAME dialog will be
displayed.
(3) The current name will be displayed on
the first line. Use the ▲/▼/◄/► buttons
and the ENTER or INPUT button to
select and enter characters. The RESET
button can be used to erase 1 character
at a time. Also if you move the cursor
to DELETE or ALL CLEAR on screen
and press the ENTER or INPUT button,
1 character or all characters will be
erased. The name can be a maximum of
16 characters.
(4) To change an already inserted
character, press the ▲ button to move
the cursor to the first line, and use the
◄/► buttons to move the cursor on the
character to be changed.
After pressing the ENTER or INPUT button, the character is
selected. Then, follow the same procedure as described at the
item (3) above.
(5) To finish entering text, move the cursor to the SAVE on screen
and press the ENTER or INPUT button. To revert to the previous
name without saving changes, move the cursor to the CANCEL
on screen and press the ENTER or INPUT button.
Using ▲/▼ buttons switches the mode for the template screen. The
selected template pattern can be displayed when the MY BUTTON
allocated to the TEMPLATE function is pressed (46).
DOT-LINE4 ó DOT-LINE3 ó DOT-LINE2

TEST PATTERN ó DOT-LINE1
Description

SCREEN menu
43