Hitachi CP-X467 Operating Manual page 35

INPUT menu (continued)
Item
COMPUTER IN
(continued)
RESOLUTION
Selecting the AUTO mode allows you to input a sync on G signal or
component signal from the port.
• In the AUTO mode, the picture may be distorted with certain
input signals. In such a case, remove the signal connector so that
no signal is received and select the SYNC ON G OFF, and then
reconnect the signal.
The resolution for the COMPUTER IN1 and IN2 input signals can
be set on this projector.
(1) In the INPUT menu, select the RESOLUTION using the ▲/▼
buttons and press the ► button.
The RESOLUTION menu will be
displayed.
(2) In the RESOLUTION menu, select the
resolution you wish to display using the
▲/▼ buttons.
Selecting AUTO will set a resolution appropriate to the input
signal.
(3) STANDARD
Pressing the ► or ENTER button when
selecting a STANDARD resolution will
automatically adjust the horizontal and
vertical positions, clock phase and horizontal
size and automatically select an aspect
ratio.
(3) CUSTOM
(3) -1 To set a custom resolution, use the
▲/▼ buttons to select the CUSTOM
and the CUSTOM RESOLUTION box
will be displayed. Set the horizontal
(HORZ) and vertical (VERT) resolutions
using the ▲/▼/◄/► buttons.
It is not guaranteed to work this function properly on any
resolutions.
(3) -2 To save the setting place the cursor
on the right-most digit and press the
► button.
The horizontal and vertical positions,
clock phase and horizontal size will be
automatically adjusted.
(3) -3 To revert back to the previous
resolution without saving changes
place, the cursor on the left-most digit
and press the ◄ button.
The screen will then return to the RESOLUTION menu
displaying the previous resolution.
• For some pictures, this function may not work well.
Description
INPUT menu
STANDARD
↓
CUSTOM
↓
35