Image Menu - Hitachi CP-X467 Operating Manual

IMAGE menu

From the IMAGE menu, items shown in the table below
can be performed.
Select an item using the ▲/▼ cursor buttons, and press
the ► cursor button or ENTER button to execute the
item. Then perform it according to the following table.
Item
ASPECT
OVER SCAN
V POSITION
(continued on next page)
Using the ▲/▼ buttons switches the mode for aspect ratio.
For a computer signal or MIU signal
NORMAL ó 4:3 ó 16:9 ó SMALL
For an HDMI signal
NORMAL ó 4:3 ó 16:9 ó 14:9 ó SMALL
For a video signal, s-video signal or component video signal
4:3 ó 16:9 ó 14:9ó SMALL
For no signal
4:3 (fixed)
• The NORMAL mode keeps the original aspect ratio of the signal.
Using the ▲/▼ buttons adjusts the over-scan ratio.
Large (It reduces picture) ó Small (It magnifies picture)
• This item can be selected only for a video, s-video, component
video and HDMI signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
Using the ▲/▼ buttons adjusts the vertical position.
Up ó Down
• Over-adjusting the vertical position may cause noise to appear on
the screen. If this occurs, please reset the vertical position to the
default setting.
Pressing RESET button when V POSITION is selected will reset V
POSITION to the default setting.
• When this function is performed on a video signal, s-video signal,
or component video signal, the range of this adjustment depends
on OVER SCAN (above) setting. It is not possible to adjust when
OVER SCAN is set to 10.
• This item cannot be selected for an HDMI signal.
Description
IMAGE menu
31