Plugging In Motor - Craftsman 113.241680 Owner's Manual

4. if the head is not square with the bar, adjustments
are required,
A. Loosen the "knob" (1) and the "two screws"
(2),
B. Position the HEAD square with the BAR using
a combination square.
C. PUSH the STOP PiN into theslot in the head a t
"0"... push the pin into the slot and twist it.
Lock the knob.
D. Recheck with the square. If the head is still not
square, loosen the screws (2) and readjust the
INDICATOR BLOCK,
E. With the head square with the bar and the pin
pushed into the slot adjust the pointer (3) to
point to "0".
F. The miter gauge head must rest on top of the
bar without being able to move up and down
. . yet it must swivel freely.
G. The swiveling movement of the head can be
adjusted by tightening or loosening the
setscrew (4) . .. using the 1/8 in. setscrew
wrench.
NOTE: The setscrew is located inside of the
head. To reach it, swivel the head to 60
degrees and turn the miter gauge upside
down.
1/8 IN. SETSCREW
WRENCH
PLUGGING IN MOTOR
1. From among the loose parts, find two wire ties.
2. Route motor cord along right side of cabinet and
snap ties in 1/4" hole in side of cabinet. Secure
two cords in wire ties.
3. Plug motor cord into outlet on side of switch box.
WiRE TIES
EXTENSION REMOVED FOR
PICTURE CLARITY