Table of Contents
Advertisement
PLOUGHING
AND MOLDING
PLOUGHING
is grooving
with the grain
the long
way of the workpmece, using the fence. USE proper
holddowns
and feed devices.
PLOUGHING
MOLDING
is shaping the workplece with the grain
the long way of the workpiece, using the fence. Use
proper hoiddowns
and feed devices.
MOLDING
RESAWING
RESAWING is a "thru-sawing"
cut made by ripping
a piece of wood through
its thickness.
Do not
attempt
to resaw BOWED or WARPED
material.
NOTE: To RESAW a Piece of wood wider than 3-3/8
in.... it will be necessary to remove the blade guard
• . . and
use the
AUXILIARY
FENCE/WORK
SUPPORT. (See "Work Helpers"),
Clamp it to the table so that the workpiece
will
SLIDE EASILY but not TILT or MOVE SIDEWAYS
between the two fences.
Do not clam p directly to the bottom edge of the table
because the "swivel"
of the clamp will not grip
properly. Place a small block of wood between the
bottom edge of the table and the "C" clamp.
WARNING: FOR YOUR OWN SAFETY ...
1. DO
NOT
"BACK
UP" (REVERSE
FEEDING)
WHILE
RESAWING
BECAUSE
THIS
COULD
CAUSE A KICKBACK.
SMALL
BLOCK
OF
WOOD
i&\
2. MAKE FIRST PASS TO A DEPTH SLIGHTLY
LESS THAN ONE-HALF
THE WIDTH
OF THE
BOARD;
KEEP
SAME
FACE
OF
BOARD
AGAINST
FENCE FOR SECOND PASS AS THE
FIRST PASS.
3. iNSTALL BLADE GUARD IMMEDIATELY
UPON
COMPLETION
OF
THE
RESAWING
OPERATION.
RABBETING
RABBETING is known as cutting out a section of the
corner of a piece of material, across an end oralong
an edge.
To make a RABBET requires cuts which do not go
al! the waythrough the material. Therefore the blade
guard must be removed.
1. Remove
blade
guard.
Use
caution.
Use
featherboards
and push sticks, etc. as required.
2. For rabbeting
along an edge (long way of
workpiece)
as shown, add facing to rip fence
approximately as high as the workpiece is wide.
Adjust
rip
fence
and
blade
to
required
dimensions; then make first cut with board flat on
table as any rip (typel cut; make second cut with
workpiece on edge. Follow all precautions, safety
instructions, and operational instructions
as for
ripping, or rip type operations, including feather
boards and push stick, etc.
3. For,rabbeting across an end, for workpiece 10-
1/2' and narrower make the rabbet cut with the
board fiat on the table using the miter gauge fitted
with a facing. DO NOT use the rip fence.
RAB|
FIRST
CUT
1
#,
I SECOND
CUT
if
I
WARNING:
FOR YOUR OWN SAFETY, INSTALL
BLADE
GUARD
IMMEDIATELY
UPON
COMPLETION
OF RABBETING
OPERATION.
Rabbet cuts can also be made using the dado head
or molding head.
36
Hide quick links:
Advertisement
Table of Contents
