Plugging In Motor - Craftsman 113.298141 Owner's Manual

Press guard onto support so that bottom of guard is
approximately 3/4 in. away from belt.
NOTE: To remove guard, lift up on LONG TABS of
cl ps ... pull guard outward. The clips should remain
on the BELT GUARD SUPPORT.
1
3/_ IN.
PLUGGING IN MOTOR
1. From among the loose parts, find two wire ties
2. Route motor cord along right side of cabinet and snap
ties in 1/4" hole in side of cabinet. Secure two cords in
w_re ties.
3. Plug motor cord into outlet on side of switch box.
NIRE TIES
19