Blade Tilt Or Squareness Of Blade To Table - Craftsman 113.241680 Owner's Manual

.9. Using a wood block and hammerasshown, move
rear support bearing to right or left as required to
realign the blade. If necessary, shift front support
bearing in similar manner; but do NOT move front
support bearing unless necessary. Recheck the
alignment with the square, then securely
retighten all support bearing screws.
NOTE: Be certain that the Widest blade you use
does not contact blade insert after moving
support bearing. Check this at both 0°
(perpendicular to the table) and 45 ° bevel by
rotating the fully elevated blade by hand.
Readjust as required to maintain sufficient
clearance.
BLADE TILT, OR SQUARENESS OF
BLADE TO TABLE
90 ° (SQUARE) and 45 ° (BEVEL) STOP SCREWS.
When the bevel pointer is pointing directly to the
"O" mark on the bevel scale, the sawlolade should
make a SQUARE cut 90 ° to the table.
To check for SQUARENESS:
WARNING: TO AVOID INJURY FROM
ACCIDENTAL START, TURN SWITCH "OFF" AND
REMOVE PLUG FROM POWER SOURCE OUTLET.
1. Blade should be all the way UP.
2. Place the square agai nst blade. Make sure square
is not touching the TIP of one of the saw TEETH.
O
_1 \\_
WOOD
BLOCK
I
3. Turn the tilt-lock handle (COUNTER--
CLOCKWISE) to loosen the tilt clamp screw,.
4. NOTE: Handle is spring loaded for engagement
with screw head -- must be pushed inward for
disengagement whenever necessary to obtain a
new grip on screw head.
12 • •