assembly
INSTALUNG
BELT GUARD
Model 113.298722 & 113.298762
1. Install three Clips (furnished with Guard) 90' apart
starting wHh one Clip at the end of the Guard as
shown. LONG END of Clip facing AWAY from you.
BELT GUARD
OPENING
/-
_
CLIPS
\
LONG END
2. Reinstall Motor Pulley thesame way it was when you
aligned the Belt.
3. Place Belt on Saw Pulley. insert end of Belt through
opening in END of Guard.
4. Slip Belt over Motor Pulley.
BELT
5. Press Guard onto Support sothat bottom of Guard is
approximately 3/4 inch away from Belt.
NOTE: To remove Guard, lift upon LONG TABS of
Clips, pull Guard outward. The Clips should remain
on the Belt guard Support.
3/4 iN.
PLUGGING
IN MOTOR
1. From among the loose parts find:
2 Wire Ties
wire ties.
24
EXTENSION
REMOVED
FOR
PICTURE
CLARITY
WIRE TIES