Aligning Extensions; Mounting Switch; Installing Rip Fence Guide Bars - Craftsman 113.241680 Owner's Manual

Insert four (4) 5/16-18 x 1-1/4 in. long screws
through holes in each EXTENSION then through
table. Install flat washer, Iockwashers, and nuts on
the screws... DO NOT TIGHTEN.
Align front edge of extension with front edge of saw
table. Pull Extension UPWARDS above table
surface . .. SLIGHTLY TIGHTEN SCREWS using
1/2 in. wrench.
Using small block of hardwood and hammer, tap
extension DOWNWARDS at front, center and rear,
until it is EVEN with table surface ... TIGHTEN
SC REWS.
BLOCK OF WOOD
\
ALiGNiNG EXTENSIONS
Lay REAR FENCE GUIDE BAR on table to act as a
straightedge, If outer edge of extension is higher or
lower than table surface:
1. Slightly loosen nut holding the corner support
bracket to extension using 7/16 in. wrench.
2. Move end of extension up or down until outer
edge is even with table surface.., check with
GUIDE BAR... tighten nuts.
3. Recheck INNER edge of extension to make sure it
has not moved.., readjust, if necessary.
4. Adjust right extension in same manner.
CHECK AT FRONT AND
REAR OF EXTENSION
MOUNTING SWITCH
1. From among loose parts find the following:
2 Hex Head Screws, 5/16-18 x 3/4 in. long
2 F[atwashers (dia. of hole 21/64 in.)
2 External Lockwashers __
2 Hex Nuts. 5/16-18
2. Insert two 3/4 inch screws through two flat
washers then through holes in switch.
3. Insert screws through holes eight and ten in front
fence guide bar as illustrated.
4. Install two Iockwashers and nuts. Tighten nuts.
J AM NUT
5/16-18
"_ "_ ,,,7 LOCKWASHER
@-_ ,8TH HOLE
\
/
........ ---_:F \---_-_ _ FRONT FENCE
1OTH HOLE \ _ GUIDE BAR
(UPSIDE DOWN)
%%"--- WASHER
HEX HEAD SCREW
5/16-18 x 5/8 IN.
0NSTALLmNG RiP FENCE GUIDE BARS
1. From among the loose parts find the following
hardware:
2 Hex Head Screws, 5/16-18 x 1-3/4 in. long
2 Hex Head Screws, 5/16-18 x 1 in. long
4 External Lockwashers, 5/16 in.
(approx. dia. of hole 5/16 in.)
4 Hex Nuts, 5/16-18
(approx. dia. of hole 5/16 in.)
2 Spacers, 3/4 in. dia. x 1/2 in. long
2 Self-threading nuts
1 Fence Guide Bar Rod
2. Lay guide bars on saw table.
NOTE: The various holes in the bar allows them
to be positioned on this saw and also makes
them adaptable to other models.
3. Insert a 1-3/4 inch long screw through the
THIRD hole IN THE FRONT BAR as illustrated
•.. Insert another 1-3/4 inch long screwthrough
the SEVENTH hole in bar.
LEFT SIDE OF
FRONT GUIDE BAR
(GUIDE BAR IS TO BE
TTH HOLE TURNED END FOR END
3RD HOLE AFTER SCREWS ARE
"_:_ _J" _ HEX _HEAD
4. Place spacers on screws.
19