Go Target Program - Epson S1C62 Family Reference Manual

ICE CONTROL SOFTWARE ICS62XX
G
Format
#G
#G,<address >
#G,R
Function This instruction runs the target program. When a break condition is detected, program
execution is halted and the break status is displayed to complete the instruction.
Setting the Starting Address
(1) When an <address> is entered, the run starts from that address.
(2) With an R setting the evaluation board CPU is reset, and the run starts from the reset
address 0100.
(3) When the <address> and R setting are defaulted, the run starts from the current
address (PC which displays the status during the previous break).
When G
evaluation board CPU is not reset.
Break Mode and Break Condition
Item
1
2
3
Note: Refer to Section 2.3.2, "Break mode and break function" for more information on the
break mode.
VIII-60

GO TARGET PROGRAM

is entered after power on, the run starts from address 0100, but the
Break mode (note) Break condition
Break enable mode * Reset switch
& break stop mode * Break switch
* Break set commands
(BA, BD, BR, BM)
* ESC input
Break enable mode * Reset switch
& break trace mode * Break switch
* ESC input
BSYN mode * Reset switch
& break stop mode * Break switch
* ESC input
Mode at power on.
When the break condition and evaluation
board CPU executed cycle coincide,
the bleak status alone is displayed and
the GO command is restarted.
When the break condition and evaluation
board CPU executed cycle coincide,
a pulse is output to the SYNC pin.
EPSON
DEVELOPMENT TOOL REFERENCE MANUAL
Comments
S1C62 FAMILY