EPOX EP-6VBA User Manual page 64

Appendix
61 1. Try to turn on Level 2 cache.
Note: If L2 cache is already turned on in POST 3D, this part will
be skipped.
2. Set the boot up speed according to Setup setting.
3. Last chance for Chipset initialization.
4. Last chance for Power Management initialization. (Green`
BIOS only)
5. Show the system configuration table.
62 1. Setup daylight saving according to Setup value.
2. Program the NUM Lock, typematic rate & typematic speed
according to Setup setting.
63 1. If there is any changes in the hardware configuration, update
the ESCD information. (PnP BIOS only)
2. Clear memory that have been used.
3. Boot system via INT 19H.
FF System Booting. This means that the BIOS already pass the
control right to the operating system.
POST (hex) DESCRIPTION
B0 If interrupt occurs in protected mode.
B1 Unclaimed NMI occurs.0
A-8
EP-6VBA