Operating Test - Fujitsu FI-590PRF Operator's Manual

8. Remove protection tape from the print cartridge.
Do not touch the metal part of the cartridge
ATTENTION
nor put the tape back again.
9. When the lever is closed, rotate the lever toward
left to open before placing the print cartridge.
●
Insert the cartridge with its Tab positioned
ATTENTION
toward left side and install it.
●
Note that the cartridge cannot be inserted
properly if it is inclined.
10. Turn the lever on the print cartridge toward right
to fix it.
11. Close the imprinter cover.
6 |

2.2 Operating Test

After installing the imprinter, test to see if printing can be
performed on the Offline Print Test mode.
1. While pressing the [Hopper Height] button (
) on the operator panel, switch on the scanner.
Continue pressing on the [Hopper Height] button.
Tab
2. Release the [Hopper Height] button when the
Function Number Display changes from [P] to [b].
3. Place a blank document on the Hopper.
ATTENTION
4. Press [Scan] button to test.
Paper will feed into the Hopper, and the Imprinter
will print out the Print Test Characters starting at
5mm (±4mm) from the paper's edge.
●
Use A4 or Letter size paper. If the size is
smaller than A4 or Letter, printing may not
successfully complete.
●
Confirm that the Print Cartridge is
positioned within the document width.
or