Download  Print this page

Test Print - Fujitsu FI-718PR Operator's Manual

Imprinter
Hide thumbs

Advertisement

6.
Remove the protective tape from the print
cartridge.
ATTENTION
Do not touch the metal part of the cartridge nor put the
protective tape back on.
7.
Place the print cartridge into the holder as
shown below with its tab pointing to the right.
ATTENTION
Be careful not to let the print cartridge touch or catch onto
the print circuit film.
8.
Lower the print cartridge holder until it locks in
place.
9.
Position the print cartridge holder along where
the document will pass through.
6 |
10. Close the print cartridge cover.

2.3. Test Print

After installing the print cartridge, check if the printing
operation can be done.
HINT
For details about the operator panel, refer to the Operator's Guide
provided with the scanner.
1.
Press the [Power] button on the operator panel
on the scanner.
 The [Ready] screen is shown on the LCD.
2.
Load a blank document in the ADF paper chute
(feeder).
HINT
● Use an A4 or Letter size blank sheet. If the paper
size is smaller than A4 or Letter, printing may not
complete successfully.
● Confirm that the print cartridge is positioned
within the document width.

Advertisement

Table of Contents
loading

  Also See for Fujitsu FI-718PR

  Related Manuals for Fujitsu FI-718PR