2.3. Operation Test
After installing the Imprinter, check if the printing operation
can be done in the Offline Print Test mode of the scanner.
1. While pressing [Function] button on the operator
panel, press
button.
Keep pressing [Function] button.
2. Release [Function] button when the Function
Number Display changes from [P] to [b].
Function
Function
Send to
Function Number Display
Scan
3. Place a blank document on the ADF paper chute.
●
Use A4 or Letter size paper. If the size is
ATTENTION
smaller than A4 or Letter, printing may not be
completed successfully.
●
Confirm that the Print Cartridge is positioned
within the document width.
4. Press [Scan] button.
The paper is fed into the ADF. Test pattern 1 (
the right figure) is printed on the paper starting 5mm
(the range of error is ±4mm) from its leading edge.
HINT
Function
of
5. To stop Offline Print Test mode, press
The scanner will be turned off.
There are following print test patterns:
( )
Test pattern 1
(Horizontal)
ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`0000
0000
(2)
Test pattern 2
(Horizontal)
abcdefghijklmnopqrstuvwxyz{|}~ 00000000
(3)
Test pattern 3
(Horizontal):
!"#$%&()*+,-./0123456789:;<=>?@00000000
(4)
Test pattern 4
(Vertical):
ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`00000000
(5)
Test pattern 5
(Vertical):
abcdefghijklmnopqrstuvwxyz{|}~ 00000000
(6)
Test pattern 6
(Vertical):
!"#$%&()*+,-./0123456789:;<=>?@00000000
When multiple sheet of documents are set on the
ADF, the Test print repeats the Pattern from 1 to 6.
The numbering data portion "00000000" changes
from 0 (Zero) with increment of 1(one).
6
5
4
3
2
Test pattern print sample
fi-553PR Imprinter Operator's Guide | 7
:
:
5mm
button.