Lcm Commands; Enable Command (Address Limit) - Cabletron Systems SmartSTACK ELS10-27TX Supplement Manual

Cabletron systems switch supplemental guide

Table of Contents

2.5 LCM COMMANDS

The following is a list of commands that were modified for this release:

• Enable Command

• Route Command

• Port Command

• Switch Command

• Trap Control Command

• VLAN Command

Commands are listed alphabetically in this chapter.

The address limit parameter was added to the enable command. If you set a limit

on a port, the number of end user devices that can have connectivity will be

limited. This is done by limiting the number of MAC addresses that can be

learned on that port.

The format is:

enable [PORT-RANGE [RIP] [TransmitPacing] [ADDRESS_LIMIT]]

The default is "no limit" to the number of addresses that can be learned on a port.

If you set the limit to zero, you allow unlimited access. If you enable a port

without specifying an address limit, you remove the limit that was in effect.

Enhancements to LCM Commands

2-5

Table of Contents

Do you have a question about the SmartSTACK ELS10-27TX and is the answer not in the manual?