Lcm Command Syntax - Cabletron Systems SmartSTACK ELS10-27TX Supplement Manual

2.3.2 LCM Command Syntax

The following is a subset of LCM commands and syntax:
switch [802.1d | 802.1Q]
cut[-through] | store[-and-forward]
[back[pressure] {on | off}]
enable [PORT-RANGE [RIP] [TransmitPacing] [Address_Limit]]
port [PORT-RANGE [speed {auto | 10[Mbps] | 100[Mbps]}]
[vlan {name |VLAN-ID}] (The default VLAN ID for that port.)
[GVRP {On | off}]
[access {add | del[ete]}]]
reboot [SECONDS [down[load]] | off]
[par[ameters] PATH [IP-ADDR [GATEWAY-ADDR]]]
route [add | del GATEWAY-ADDR]
[display [IPADDR]]
vlan [add PORT-RANGE NAME VLAN-ID [IP-ADDR] [MASK]]
[del[ete] PORT_RANGE NAME VLAN-ID]
[res[trict] {add | de[lete]} PORT-RANGE VLAN-ID]
trunk [add PORT-RANGE]
[del[ete] PORT-RANGE]
workgroup [NAME [{del[ete] | PORT_RANGE [INFO]]}]
Enhancements to LCM Commands
2-3