Cabletron Systems SmartSTACK ELS10-27TX Supplement Manual page 83

Configuring Workgroups Using SNMP
If ports are added to an existing workgroup, the index into the workgroup table
would be written to els10-27WorkGroupNumber. This would be obtained by first
reading all of the entries in the workgroup table. The name of the workgroup you
want to add ports to would be written to els10-27WorkGroupName.
If a workgroup was to be deleted, the index into the table and the workgroup
name would be used, as in the previous example, any value should be written to
els10-27WorkGroupPorts. However, a value of 4 would be written to els10-
27WorkGroupType to perform a delete.
You must delete the Workgroup in its entirety. You cannot delete
NOTE
part of a Workgroup.
6-3