C2K122-24 Stackable Switch - Enterasys C2K122-24 Hardware Installation Manual

Enterasys gigabit ethernet switch installation guide

Hide thumbs Also See for C2K122-24:

Release note (41 pages)

Table Of Contents

Table of Contents

Overview

C2K122-24

The C2K122‐24 (Figure

connections, which include:

•

Twenty four RJ45 ports (10/100/1000 Mbps, 1000BASE‐T copper ports).

•

XFP slots that provide you with the option of installing XFP MSA compliant modules

for 10‐Gigabit, 10GBASE‐L/‐LR/‐ER fiber‐optic uplink connections.

•

Rear panel connectors for high‐speed connections in a stack configuration.

•

Rear panel Redundant Power Supply connector for a redundant power supply

connection. The switch connects to an Enterasys C2RPS‐SYS using a C2RPS‐PSM

Cable.

The 10/100/1000 Mbps fixed front panel ports can operate in either half‐duplex or full‐

duplex mode, as determined by Auto‐Negotiation.

Figure 1-1

1 DB9 RS232 console port connector

2 Status LEDs

3 Twenty-four RJ45, 10/100/1000 Mbps ports

4 RJ45 port status LEDS

5 Two slots for XFP interface modules

1-2 Introduction

1‐1) has several types of front panel port and rear panel

Caution: The C2K122-24 is not a PoE-compliant device. Do not connect a SecureStack

C2 PoE Redundant Power System (C2RPS-POE) to the power connector. Otherwise,

damage to the device may result.

Precaución: El dispositivo C2K122-24 no cumple con el estándar PoE. No conecte una

fuente de poder redundante (RPS) SecureStack C2 PoE (C2RPS-POE) al cable de

corriente directa. De lo contrario, el dispositivo puede dañarse.