Setting The Mode Switches; B-2 Mode Switch Location - Enterasys 2200 Installation & User Manual

B.3

SETTING THE MODE SWITCHES

Figure B-2 shows the location of the mode switches and the switch settings for normal operation.
These switches are set at the factory and rarely need to be changed.
Switch definitions and positions are as follows:
•
Switches 1 through 4 – For Enterasys Networks use only.
•
Switch 5 – COM Port Autobaud. The default (OFF) position enables Autobaud sensing on the
COM port for Local Management sessions. Changing the switch to the ON position disables
Autobaud sensing and sets the COM port to 9600 baud for Local Management sessions.
Figure B-2 Mode Switch Location
Optional Installations and Mode Switch Bank Settings
Setting the Mode Switches
B-5