Using The Reset Button - Enterasys 2200 Installation & User Manual

Using the RESET Button

4.3 USING THE RESET BUTTON
The RESET button shown in
CAUTION: Pressing the RESET button resets the device, and all current switching
being performed by the device is halted. A network downtime of up to two minutes will
result from this action.
Figure 4-2 RESET Button
To reset the 2H258-17R processor, press and release the RESET button. The 2H258-17R goes
through a reset process for approximately 60 seconds. Additional downtime may result as the
device reenters the network.
NOTE: It is not recommended to press the RESET button while the device is already in
reset mode. If so, the device will enter an extended diagnostic procedure, which is
unnecessary for normal operation. This extended diagnostic procedure takes much
longer than a minute.
4-8 Troubleshooting
Figure 4-2 resets and re-initializes the 2H258-17R.