Blade Elevations - Craftsman 113.298090 Owner's Manual

8. If blade is NOT 45 ° to table, the 45 ° Stop Collar must
be adjusted.
A. Remove Elevation HandwheeL
B. Using a small size screwdriver, reach thru curved
slot in front trim panel and loosen BOTH setscrews
in 45 ° Stop Collar.
NOTE: If you can't reach the setscrews, turn the Tilt
Handwheel slightly.
C. Rotate the Stop Collar moving it IN or OUT and tilt
blade RIGHT or LEFT, checking with your square,
until blade is 45 ° to table.
D. Tighten the setscrews.
NOTE: If you can't reach the setscrews, turn Tilt
Handwheel slightly.
E. Install Elevation Handwheel.
45 °
STOP COLLAR
TILT SCREW
BACK OF SAW
BLADE ELEVATION
Whenthe Elevation Handwheel isturned CLOCKWISE,
until it stops, the blade must not be more than 2-5/8
inches above the table. If the blade extends more than
2-5/8 inches, the motor could interfere with the under-
side of the table causing misalignment.
With the blade extending 2-5/8 inches above the table,
the Stop Collar and Spacer must be against the Eleva-
tion Screw Pivot Nut. If the blade extends more than 2-
5/8 inches, loosen two screws in Stop Collar, and
readjust it.
;TOP
_LLAR
ELEVATION SCREW
/
;PACER
/
/
ELEVATION SCREW
PIVOT NUT
TILT SCREW
TILT SCREW
PIVOT NUT
17