Getting To Know Your Saw; On-Off Switch; Elevation Handwheel; Tilt Handwheel - Craftsman 113.298090 Owner's Manual

getting to know your saw
BOTH MODELS 6 BLADE GUARD
MITER GAUGE
LOCK KNOB
8 SAW BLA
5 MITER GAUGE
MITER
HEAD
SPREADER
ANTIKICKBACK
PAWLS
TABLE INSERT
4
FENCE
3
9 EXACT-I-CUT
TILT HANDWHEE|
HOLES FOR
ATTACHING
FACING
2
ELEVATION HANDWHEEL
/
/
FENCE
LOCK KNOB
1
ON-OFF SWITCH
ON-OFF SWITCH
CAUTION: Before turning switch "ON", make i
sure the blade guard is correctly installed and
operating properly.
The On,Off Switch has a locking feature. THIS
FEATURE IS INTENDED TO PREVENT UN-
AUTHORIZED AND POSSIBLE HAZARDOUS USE
BY CHILDREN AND OTHERS.
A. Insert key into switch.
B_To turn saw ON, stand to either side of the blade,
never in line with it, insert finger under switch lever
and pull END of lever out.
After turning switch ON, always allow the blade to
come up to full speed before cutting.
Do not cycle the Motor Switch on and off rapidly, as
this may cause the sawblade to loosen, in the
eventthis should ever occur, allowthe sawblade to
come to a complete stop and re-tighten the arbor
nut r_rmatly, not excessively. Never leave the saw
while the power is "ON".
C. To turn saw OFF, PUSH leverin. Never leavethe
saw until the cutting tool has come to a complete
stop.
D. To dock switch in OFF position, hold switch IN with
one hand, REMOVE key with other hand.
32
C
@
KEY
(YELLOW PLASTIC)
© © ____
_.----__
I'
k,,,