Craftsman 113.298090 Owner's Manual page 21

7, _nsert one inch _ong screw and flat washer in F_RST
8_
9.
THIRD and EIGHTH sbt of the rear Guide Bar and
attach lo table and mounting bracket using
_ockwashers and hex nuts as illustrated_ Hand
tighten at this time,
1_' HE;< HD.
SCREW
FLAT WASHER
LOCKWASHER _"_ _
",, 9'
REAR NUT ............. ;_
GUiD E BAR
==========================================================_:_:`_;_`._::::_::_t:_`_L_Z_-`_`_ -....
L_z_ i SLOT
/ _ I 3RD' SLOT
8TH SLOT
tFOR MOUNTING
TO BRACKET) t
Slide the Front Guide Bar as far as it wilt go to the right
and the Rear Guide Bar as far as i1will go to the lefL
Position Rip Fence at left end of Front Guide Bar,
holding up the rear end while engaging front end with
Front Guide Bar. Lower fence onto tab!e_
NOTE: It may be necessary to loosen Fence Knob
to allow Fence to be installed on Rear Guide Bar.
\\\
Front Guide Bar upwards until fence is ap*
10. Move
proximately 1/32 inch above tabae. Tighten screw at
left end of Bar.
NOTE: Fotd a piece of newspaper making 8 thick-
nesses and place between Rip Fence and table to
act as a spacer. This will tloid the Fence off of tl_e
table approximately 1/32 inch.
Adjust Rear Guide Bar so that the Fence is approxi-
mately 1/32 inch above table, Tighten screw at end
of Bar.
11. Move fence to right edge of table. Make sure it is
approximately 1/32 inch above table at front and rear
and tighten four remaining screws.
8 THICKNESSES
OF PAPER
8 THICKNESSES
OF PAPER
\