Craftsman 113.298090 Owner's Manual page 24

assembly
3. Mount Switch to Guide Bar with two 5/16-18 x 3/4 hex
head screws, Iockwashers, and nuts. Securely tighten
both nuts.
5/16-18 HEX NUTS
_/" "l j
EXTERNAL LOCKWASHERS
_"\_ EXTERNAL LOCKWASHERS
5/16-18 X 3/4 HEX HD. SCREWS
4. Place Front Guide Bar against saw table and drop it
in place engaging the screws in the slots. Make sure
the spacers are between the rail and the table.
5. End of Front Guide Bar must be 7-5/16 in. from side
of saw table. This is important so that Rip Fence
Indicator can be aligned.
6. With the blade of your combination square set to 1/4
inch, gauge and adjust guide rail so the edge of the
rail is 1/4 inch ABOVE the edge of the table. Securely
tighten nuts.
7. Install 5/16-18 x 1-1/2 hex head screw through the
FOURTH slot in Front Guide Bar (that lines up with
bracket), through the 1/2 inch spacer and the Bracket.
Install a 5/16 in. external iockwasher and 5/16-18 hex
jam nut.
5/16-18 x 1.1/2
HEX HD.
/ 1
/
7-5/16 IN,
8. Remove the three screws from rear of right table
extension.
9. Attach the Rear Guide Bar in a similar manner to the
Front Guide Bar. Make sure that the end of the bar
is 1! inches from the side of the saw table.
10. Reinstallthree truss head screws, Iockwashers and
istight.hex nuts removed in step 8. Check that all hardware _-_'<_)_l__\_ J
11. insert 5/16-18 x 1 hex head screw through the
EIGHTH slot and bracket. Install 5/16 external . SCRE
iockwasherand5116 hex jam nut. Tighten securely. HEX HD. TRUSS HD.
SCREWS
SCREWS
24