Rip Fence Alignment Adjustment; Adjusting Rip Scale Indicator - Craftsman 113.298090 Owner's Manual

assemb|y
Loosen the screws.
2. Move spring slightly towara front ot Fence. Tighten
screws,
# the Fence does not slide easily a_ong _he Bars the
press_re of the spring can be REDUCED
1 Loosen tr_escrews
2. Move spring sJight_ytoward rear of Fence
Tig,q_en
SCreWS.
/
/
SLIDE SPRING TO
ADJUST PRESSURE
RiP FENCE ALBGNMENT ADJUSTMENT
WARNING: A misaltglned Rip Fence can cause
kickbacks and jams. To avoid injury, !ol!ow these
instructions until the fence is prepedy aligned.
The Rip Fence must be PARALLEL with the sawbtade
and Miter Gauge Grooves. Move Fence untiJ it is a_on_
s_deot Groove, DO NOT LOCK iT I! should be paralle_
to Groove. _fi_ is not:
1 Loosen the Hex },-leadscrews,
2 Hold Fence head tightly against Bar, Move end ot
Fence so that =tis parallel with Groove,
3, Alternately tighten the screws
4 Re-check alignment.
5. Repeat steps, as needed
ADJUSTING RiP SCALE iNDiCATOR
1, Turn Elevation Handwheei clockwise untit blade is up
as high as it will go.
BMPORTANT: BLADE musl be SQUARE 190'_) to
[ABLE, in order to ALIGN Rip Fence,
2, Using a rule, position Fence on right side of sawblade
2 inches from the side of the teeth, tighten Lock
Handle.
3, Loosen screw holding the Indicator, adjust so that it
points to "2" on the Rip Scale, tighten screw.
NOTE: It you cannot adjust indicator so that it points
to "2." loosen the screws holding the Front Guide Bar
and move the Guide Bar.
HEX SCREWS
FENCE HEAD
\
\
\
LOCK HANDLE
28