Tilt And Elevation Mechanism; (Model 113.226880) - Craftsman 113.298090 Owner's Manual

assembly
TiLT AND ELEVATION MECHANISM
The Handwheels should turnfreely without binding. The
turning action can be adjusted bytightening or loosening
the screws in the Bearing Retainer. Both Handwheels
must be removed to reach the adjusting screws.
NOTE: When adjusting the screws on the Tilt Bearing
Retainer, hold the nut inside using a 3/8 inch wrench.
The screws for the Elevation Bearing Retainer can be
reached with a small screwdriver through the curved slot
on the front of the saw.
TILT
HANDWi_EEL
ADJUST THESE
TWO SCREWS
_ELEVATaON
ADJUST THESE
TWO SCREWS
MODEL 113.226880 ONLY
ATTACHING AND ASSEMBLING
TABLE EXTENSIONS
1. From among the loose parts, find the following hard-
ware: (Quantity indicated is for 2 extensions.)
*8 Hex Hal. Screw 5/16-18 x 1
*8 Flat Washer, 21/64 x 5/8 x 1/16
*8 Lockwasher, External 5/16
*8 Hex Jam Nut, 5/16-18
2 Brackets
Items rnarked with an asterisk (*) are shown actual size.
5/16-18 x 1
HEX HD. SCREW
11/32 IN. I.D.
FLAT WASH ER
5/16 IN. EXTERNAL 5tl 6 IN.
LOCKWASHER HEX NUT BRACKET
2. Insert three (3) 5/16-18 x 1 inch long screws through
holes in table.
3. Position Extension against table so screws extend
though holes in Extension.
4. Install flat washer, Iockwashers, and nuts on the
screws. HAND TIGHTEN ONLY.
5. Install other extension in the same way on other side
of table.
\
LOCKWASHER
FLATWASHER
18