Installing Drive Belt And Adjusting Belt Tension - Craftsman 113.232210 Owner's Manual

j,ll,_l
INSTALLING DRIVE BELT AND
ADJUSTING BELT TENSION
WARNING: DO NOT LETANY PART OFYOUR BODY
TOUCH THE CUTTER HEAD. tT CONTAINS VERY
SHARP CUTTER KNIVES WHICH COULD CUT YOU
BADLY.
1. Fromthe loose parts find the drive belt and the putiey.
From the packing material used in the jointer box,
find two (2) large pieces of styrofoam.
SPECIAL NOTE: When turning the JointeriPtaner up-
side down do not put the weight of the Jointer/Planer
on the guard or the guard may be broken. Do not roll
the JointedPlaner over because this may also break
the guard.
2. Put the two pieces of styrofoam on the floor and put
the JointeriPlaner upside down on the cardboard as
MOTOR CUTTER HEAD
illustrated.
WARNING: DO NOT TURN: THE MOTOR ON UNTIL
:THE JOINTERiPLANER IS COMPLETELY ASSEM- : : :
BLED AND TURNED RIGHTSIDE: UP WITHiTHE i : i_: :
LEVELING FEET SETTING AGAINSTTHE FLOOR_ :_:
IF THIS WARNING IS NOT FOLLOWED THE MOTOR MOTOR
AND START SWITCH MAY BE BURNED OU_'YOUI MOUNTING
COULD ALSO BE BADLY CUT BYTHE VERY SHARP = BOLTS
KNIVES ON THE CU_ER HEAD_ :: ', :' :
3. Locate the two motor: mounting bolts on the under-
side of the j0inter. Using a 1/2, _ Socket, 6" extension,
and a Socket wrench loosen these two moto_ mount-
ing bolts. .........
4. Slide the motor: pUiley onto the motor shaft as illus-
trated with the set screw side of pulley toward the
jointer, i
MOTOR
PULLEY
•
CUTTER
PULLEY
13