Lubrication - Craftsman 113.232210 Owner's Manual

5 RAISE the end of the FENCE, rotate the guard
COUNTER clockwise onIy enough to CLEAR fence
6. LOWER the fence and tighten both knobs
The normal position of the guard (at REST) when the
fence is stationed at MAXIMUM WIDTH OF CUT, is
shown as position "A" NEVER ROTATE GUARD
BEYOND POSITION "B" BECAUSE THIS WOULD
EXERT EXCESSIVE TENSION ON SPRING WHICH
COULD WEAKEN OR BREAK IT
Check operation of GUARD and SPRING
1 With fence in MAXIMUM WIDTH OF CUT position,
pass a piece of 1/4 in thick wood on edge (jointing
position) over cutterhead
2 The guard should return automatically to its REST
position against the fence when free of the wood
3. If guard does not return to its REST position, remove
the guard by following steps 1 thru 6 above Make
sure the spring is installed correctly and not broken
If the spring is broken it must be replaced
Reassemble the guard and spring and test again by
following steps 1 and 2
If guard still does not return to its REST position, consult
your local Sears Retail Store before using the jointer
planer
POSITION "A _'
lubrication
The BALL BEARINGS in this machine are packed with
grease at the factory. They require no further lubrication
The following parts should be oiled occasionally "with
SAE No 20 or No 30 engine oil
1 Dovetail spacer and dovetail slide
2, Elevating screw (first clean with Craftsman Gum and
Pitch Remover).
\
\\
DOVETAIL
SPACER AND SLIDE
35
ELEVATING SCREW
VIEW LOOKING UP FOR
PARTS fDENTIF1CAT!ON