Table of Contents
Advertisement
Orient the Backrest (16) as shown. Attach the
Backrest to the Upright Base (2) and the Upright
(3) with two M6 x 100mm Screws (71) and two
M6 Washers (85).
Attach the Center Cover (59) to the Front Mech
Cover (13) with two M4 x 20mm Selfotapping
Screws (94).
7.
Set the Mech Frame (10) on the Base (1).
Attach the Mech Frame (10) to the Upright Base
(2) with an M12 x 30mm Bolt (109). Do not tight-
en the Boff yet.
Tip the resistance system onto its side. Attach the
Mech Frame (10) to the Base (1) with four M10
Nylon Locknuts (74).
Tighten the M12 x 30ram Bo_t (!09). Tighten
the MI0 Nylon Locknuts
(74) used in step 3.
/ /
//'
//
Wide _2-._
/
End
_--Y
85
_2
94
/
13
l
//
//
/
10
8
Hide quick links:
Advertisement
Table of Contents
