14, Grease an MIO x 72mm BoUt(101), Attach the
Leg Lever (8) to the Seat Frame (6) with the BoUt
and an MIO NyUonLocknut (74), Do not over-
tighten the Locknut;
the Leg Lever must be
able to pivot easily.
15, Side two Smal Foam Pads (25) onto the Leg
Lever (8), Press two Endcaps (57) onto the Leg
Lever,
Repeat this step with the Seat Frame (6}.
16, Set the Seat Frame (6) on the Upright Base (2),
17, Attach the Cull Pad (29) to the Cull Post (9) with
two M6 x 16mm Screws (72),
18, Make sure that al parts have been properly
tightened
before the resistance
system
is
used.
14
15
16
17
57
25
Grease
l
6
74
25
57
72
29
/
11