Installing The Voice Feature Card - Cisco AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle Installation Manual

Chapter 6 Voice Feature Card
OIR events:
DFC State is DFC_S_REMOVED

Installing the Voice Feature Card

Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
When you replace a feature card in a slot with a new feature card of the same type, the system software
Note
recognizes the new feature card and brings up the trunk interfaces automatically. If you replace the
existing feature card with a new feature card of a different type, you must reconfigure the system. For
configuration details, see the
Configuration
To install the voice feature card, follow these steps:
Attach an ESD-preventive wrist strap.
Step 1
Step 2 Slide the feature card into the slot until the connector pins make contact with the carrier card backplane
connector. (See
Figure 6-9
Figure 6-10
Step 3 Align the captive screws with their holes, and then seat the card completely.
Seat the feature card in the carrier by pushing the card firmly until the captive screws are aligned with
Step 4
their holes.
Tighten the screws to secure the feature card to the chassis. (See
Step 5
78-17406-01
Number of insertions = 0, Number of removals = 1
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software
Guide.
Figure 6-9 and Figure
Installing a Feature Card in the Cisco AS5350XM Universal Gateway
Installing a Feature Card in the Cisco AS5400XM Universal Gateway
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
Online Insertion and Removal of the Voice Feature Card
6-10.)
Figure 6-11 and Figure 6-12.)
6-7