Online Installation and Removal of the T1 or E1 Feature Card
Figure 3-12
Align the captive screws with their holes, and seat the card completely.
Step 3
Tighten the screws to secure the feature card to the chassis. (See
Step 4
Figure 3-13
Figure 3-14
Check the card LEDs to verify that the card is working properly. For information about feature card
Step 5
LEDs, see
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
3-10
Installing the T1 or E1 Feature Card in the Cisco AS5400XM Universal Gateway
Tightening the Captive Screws on the Cisco AS5350XM Universal Gateway
0
1
Rx
Tx
ACT
Captive
DFC
Captive
screw
screw
Tightening the Captive Screws on the Cisco AS5400XM Universal Gateway
Captive
Captive
screw
screw
Chapter 7, "Troubleshooting."
2 PRI
OK
Carrier
card
Chapter 3
T1 and E1 Feature Cards
Figure 3-13
and
Figure
3-14.)
Chassis
78-17406-01