Cisco AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle Installation Manual page 58

Online Insertion and Removal of the Universal Port or Dial-Only Feature Card
Figure 5-7
Avoid touching any pins or circuit board components when you remove or install a feature card.
Caution
After you remove the feature card, set it aside on an ESD-preventive mat.
Step 9
If the feature card slot is to remain empty, install a blank cover over the open feature card slot to ensure
Step 10
proper airflow inside the chassis. (See
Figure 5-8
Online Insertion and Removal Example for the Universal Port or Dial-Only Feature Card
The following output is an example of the online insertion and removal (OIR) process for a universal
port feature card in slot 3 of the universal gateway:
Router# show chassis slot 3
Slot 3:
DFC type is NP108 DFC
OIR events:
DFC State is DFC_S_OPERATIONAL
Router#
Router# show busyout 3
Slot 3 is not being busied out
Router#
Router# busyout 3
Busyout in progress for 3
Router#
Router# show busyout 3
Slot busyout is in progress
Slot 3:Pending (64 calls remaining)
Router#
Router# show chassis slot 3
Slot 3:
DFC type is NP108 DFC
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
5-6
Removing the Feature Card from the Cisco AS5400XM Universal Gateway
Blank Feature Card Cover
Number of insertions = 0, Number of removals = 0
Chapter 5
Figure 5-8.)
Universal Port and Dial-Only Feature Cards
78-17406-01