Cisco AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle Installation Manual page 47

Chapter 4 Channelized T3 Feature Card
Figure 4-3
Initialize the software busyout procedure by entering the busyout command:
Step 2
Router# busyout slot-number
Check busyout status for the slot, by entering the show busyout command.
Step 3
Router# show busyout slot-number
You can use the clear port command to immediately disable active calls on the universal port, dial-only,
Step 4
or voice feature card. For more information on the universal port or dial-only feature card, see
"Universal Port and Dial-Only Feature Cards."
Chapter 6, "Voice Feature Card."
associated with the CT3 feature card.
Router# show controller t3 slot-number/control-number timeslot timeslot-number
Router# clear port slot-number/port number
Note
Verify that the OK/MAINT LED is off; this indicates that the feature card is offline and ready to be
Step 5
removed.
Note
Attach an ESD-preventive wrist strap.
Step 6
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Disconnect all interface cables from the feature card and secure them out of the way.
Step 7
78-17406-01
Slot Numbering on the Cisco AS5400XM Chassis
Slot 0 Slot 1
Slot 2 Slot 3
Slot 4
Slot 6
Use the show controller command to show the feature card that is
The clear port command applies only to universal port, dial-only, or voice feature cards.
The OK/MAINT LED is green before you enter the busyout command. After you enter the
busyout command, the LED changes to yellow. The LED turns off after all calls are
disconnected and resources are taken out of service, indicating that busyout is complete.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
Online Insertion and Removal of the CT3 Feature Card
Slot 5
Slot 7
For more information on the voice feature card, see
Chapter 5,
4-3