Removing And Installing A Compactflash Memory Card - Cisco VG310 Installing Manual

Connecting to a Remote ASCII Terminal
• 1 stop bit
• No parity
• No flow control
Step 3 Key in and dial the telephone number of the voice gateway's external modem.
Connecting to a Remote ASCII Terminal
Procedure
Step 1 Connect the remote ASCII terminal and modem.
Step 2 Set the terminal requirements:
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• No flow control
Step 3
Key in the telephone number of the voice gateway external modem, or, if you are using a Hayes-compatible
modem, enter

Removing and Installing a CompactFlash Memory Card

This section describes how to remove and replace a CompactFlash memory card in Cisco VG310 and Cisco
VG320:
•
•
Removing a CompactFlash Memory Card
Caution
Do not remove a CompactFlash memory card from the chassis while it is being accessed. This can cause data
corruption and erratic operation. The CompactFlash memory card LED blinks to indicate when flash memory
is being accessed. Removing the CompactFlash memory card from the chassis while flash memory is being
accessed can cause data corruption and erratic operation.
Installing the Cisco VG310 and Cisco VG320 Voice Gateways
24
and the number to be dialed.
ATDT
Removing a CompactFlash Memory Card, on page 24
Replacing a CompactFlash Memory Card, on page 25
Installing the Cisco VG310 and Cisco VG320 Voice Gateways