Access-List Mac Mask-Precedence; Mask (Mac Acl) - Edge-Core ES3528-WDM Management Manual

Related Commands
permit, deny 23-13
mac access-group (23-18)

access-list mac mask-precedence

This command changes to MAC Mask mode used to configure access control
masks. Use the no form to delete the mask table.
Syntax
[no] access-list ip mask-precedence {in | out}
• in – Ingress mask for ingress ACLs.
• out – Egress mask for egress ACLs.
Default Setting
Default system mask: Filter inbound packets according to specified MAC ACLs.
Command Mode
Global Configuration
Command Usage
• You must configure a mask for an ACL rule before you can bind it to a port or
set the queue or frame priorities associated with the rule.
• A mask can only be used by all ingress ACLs or all egress ACLs.
• The precedence of the ACL rules applied to a packet is not determined by
order of the rules, but instead by the order of the masks; i.e., the first mask
that matches a rule will determine the rule that is applied to a packet.
Example
Console(config)#access-list mac mask-precedence in
Console(config-mac-mask-acl)#
Related Commands

mask (MAC ACL) (23-15)

mac access-group (23-18)
mask (MAC ACL)
This command defines a mask for MAC ACLs. This mask defines the fields to check
in the packet header. Use the no form to remove a mask.
Syntax
[no] mask [pktformat]
{any | host | source-bitmask} {any | host | destination-bitmask}
[vid [vid-bitmask]] [ethertype [ethertype-bitmask]]
• pktformat – Check the packet format field. (If this keyword must be used in
the mask, the packet format must be specified in ACL rule to match.)
• any – Any address will be matched.
23
MAC ACLs
23-15