Figure 9-4 Lacp Trunk Configuration - Edge-Core ES3528-WDM Management Manual

Command Attributes
• Member List (Current) – Shows configured trunks (Port).
• New – Includes entry fields for creating new trunks.
- Port – Port identifier. (Range: 1-28)
Web – Click Port, LACP, Configuration. Select any of the switch ports from the
scroll-down port list and click Add. After you have completed adding ports to the
member list, click Apply.
CLI – The following example enables LACP for ports 1 to 6. Just connect these ports
to LACP-enabled trunk ports on another switch to form a trunk.
Console(config)#interface ethernet 1/1
Console(config-if)#lacp
Console(config-if)#exit
. .
.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type:
Mac address:
Configuration:
Port admin:
Speed-duplex:
Capabilities:
Flow control:
Port security:
Max MAC count:
Current status:
Created by:
Link status:
Port operation status:
Operation speed-duplex: 100full
Flow control type:
Member Ports: Eth1/1, Eth1/2, Eth1/3, Eth1/4, Eth1/5, Eth1/6,
Console#

Figure 9-4 LACP Trunk Configuration

100TX
00-30-F1-D4-73-A2
Up
Auto
10half, 10full, 100half, 100full
Disabled
Disabled
0
LACP
Up
Up
None
Creating Trunk Groups
9
24-1
25-2
24-9
9-9