Show Queue Bandwidth; Table 31-3 Default Cos Priority Levels - Edge-Core ES3528-WDM Management Manual

Default Setting
This switch supports Class of Service by using eight priority queues, with
Weighted Round Robin queuing for each port. Eight separate traffic classes
are defined in IEEE 802.1p. The default priority levels are assigned according
to recommendations in the IEEE 802.1p standard as shown below.
0
Priority
2
Queue
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• CoS values assigned at the ingress port are also used at the egress port.
• This command sets the CoS priority for all interfaces.
Example
The following example shows how to change the CoS assignments to a one-to-one
mapping:
Console(config)#interface ethernet 1/1
Console(config-if)#queue cos-map 0 0
Console(config-if)#queue cos-map 1 1
Console(config-if)#queue cos-map 2 2
Console(config-if)#exit
Console#show queue cos-map ethernet 1/1
Information of Eth 1/1
Traffic Class : 0 1 2 3 4 5 6 7
Priority Queue: 0 1 2 3 4 5 6 7
Console#
Related Commands
show queue cos-map (31-6)

show queue bandwidth

This command displays the weighted round-robin (WRR) bandwidth allocation for
the eight priority queues.
Default Setting
None
Command Mode
Privileged Exec

Table 31-3 Default CoS Priority Levels

1 2 3
0 1 3
Priority Commands (Layer 2)
4 5
4 5
31
6 7
6 7
31-5