Event Logging Commands; Logging On; Table 19-9 Event Logging Commands - Edge-Core ES3528-WDM Management Manual

19
System Management Commands

Event Logging Commands

This section describes commands used to configure event logging on the switch.
Command

logging on

logging history
logging host
logging facility
logging trap
clear log
show logging
show log
logging on
This command controls logging of error messages, sending debug or error
messages to a logging process. The no form disables the logging process.
Syntax
[no] logging on
Default Setting
None
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to switch memory or sent
to remote syslog servers. You can use the logging history command to
control the type of error messages that are stored in memory. You can use the
logging trap command to control the type of error messages that are sent to
specified syslog servers.
Example
Console(config)#logging on
Console(config)#
Related Commands
logging history (19-29)
logging trap (19-31)
clear log (19-31)
19-28

Table 19-9 Event Logging Commands

Function
Controls logging of error messages
Limits syslog messages saved to switch memory based on
severity
Adds a syslog server host IP address that will receive logging
messages
Sets the facility type for remote logging of syslog messages
Limits syslog messages saved to a remote server based on
severity
Clears messages from the logging buffer
Displays the state of logging
Displays log messages
Mode Page
GC 19-28
GC 19-29
GC 19-30
GC 19-30
GC 19-31
PE 19-31
PE 19-32
PE 19-33