Destination Port Filtering; Port Fordwarding - TRENDnet TEW-715APO User Manual

TRENDnet User's Guide

Destination Port Filtering

Firewall Setting > Dst Port Filtering
The destination port filtering enables you to restrict certain ports of data packets from
your local network to Internet through the access point. Use of such filters can be
helpful in securing or restricting your local network. Please note that this feature is only
available when access point System Mode is set to Router.
1. Log into the management page (see
2. Click on Firewall Settings, and click on Dst Port Filtering. Click Apply to save settings.
• Enable Destination IP Filtering: Check this option to enable source IP filtering
• Port Range: Enter the range of ports you would like to apply the source port
filtering.
• Protocol: Select the protocol you would like to filter. From UDP, TCP or Both (UDP
and TCP).
• Comment: Enter any notes you would like to add to distinguish the rule.

Port Fordwarding

Firewall Setting > Port Forwarding
The destination port filtering enables you to restrict certain ports of data packets from
your local network to Internet through the access point. Use of such filters can be
helpful in securing or restricting your local network. Please note that this feature is only
available when access point System Mode is set to Router.
© Copyright 2012 TRENDnet. All Rights Reserved.
"Access the management page" on page 9).
1. Log into the management page (see
2. Click on Firewall Settings, and click on Port Forwarding. Click Apply to save settings.
• Enable Destination IP Filtering: Check this option to enable source IP filtering
• IP Address: Enter the IP address of the device to forward the port. (e.g.
192.168.10.101).
• Protocol: Select the protocol required for your device. TCP, UDP, or you can
select Both to choose both TCP & UDP.
• Port Range: Enter the port number used to access the device from the Internet.
• Comment: Enter any notes you would like to add to distinguish the rule.
Example: To forward TCP port 80 to your network/IP camera
1. Make sure to configure your network/IP camera to use a static IP address or you can
use the DHCP reservation feature (see "Set up DHCP reservation" on page 55).
Note: You may need to reference your camera documentation on configuring a static IP
address.
2. Log into the management page (see
3. Click on Firewall Settings on the side, click on Port Forwarding.
4. Under IP Address, enter the IP address assigned to the camera. (e.g. 192.168.10.101)
5. To save changes, click Save at the bottom of the page.
TEW-715APO
"Access the management page" on page 9).
"Access the management page" on page 9).
38