Wireless Access Control; Advance Settings; Change Your Ip Address - TRENDnet TEW-715APO User Manual

TRENDnet User's Guide
Shared Secret – Enter the shared secret used to authorize your router
o
• Global-Key Update
Enable this option to set the cache period based on seconds
o

Wireless access control

Wireless > Access Control
The MAC address filter section can be used to filter network access by machines based
on the unique MAC addresses of their network adapter(s). It is most useful to prevent
unauthorized wireless devices from connecting to your network. A MAC address is a
unique ID assigned by the manufacturer of the network adapter.
• Access Control Mode:
Disable: Access control is disabled
o
Allow Listed: Enter MAC address allowed to connect to the access
o
point
Deny List: Enter MAC addresses to block connection to the access
o
point.
© Copyright 2012 TRENDnet. All Rights Reserved.

Advance Settings

Change your IP address

Basic Setting > Primary Setup
In most cases, you do not need to change the access point's IP address settings.
Typically, the access point IP address settings only needs to be changed, if you plan to
use another access point in your network with the same IP address settings, if you are
connecting the access point to an existing network that is already using the IP address
settings your access point is using.
In addition, the access point can be used as a DHCP (Dynamic Host Configuration
Protocol) server to automatically assign an IP address to each computer or device on
your network. If you already have a DHCP server on your network, or if you do not want
to use the access point as a DHCP server, you can disable this setting. This setting would
be used when the access point's System settings is set to Router mode.
Note: If you are not encountering any issues or are not faced with one of the cases
described above or similar, it is recommended to keep your router IP address settings as
default.
Note: For VPN (Virtual Private Network) configuration, it is required that each router
should have a different router or LAN IP address/network on each end of the VPN tunnel.
Default Router or LAN IP Address: 192.168.10.1 00
Default Router or LAN IP Network: 192.168.10.0 / 255.255.255.0
1. Log into the management page (see
2. Click on System, and click on Network Settings.
TEW-715APO
"Access the management page" on page 9).
33