Dhcp Clients; Network Activity; Additional Hardware Installation; Ground Wire - TRENDnet TEW-715APO User Manual

TRENDnet User's Guide

DHCP Clients

Status > DHCP Clients
This page displays the access point's current DHCP clients.
1. Log into the management page (see
2. Click on Status, and click on DHCP Clients.
• Refresh: Click to refresh to view the current information

Network Activity

Status > Network Activity
The network activities allows you to monitor the current Wireless and Ethernet TX/RX
data traffic in graphical and numerical form on the Web of the Skyport. The chart scale
and throughput dimension (Bps, Kbps, Mbps) changes dynamically according to the
mean throughput value.
1. Log into the management page (see
2. Click on Status, and click on Network Activity.
• Refresh: Click to refresh to view the current information
© Copyright 2012 TRENDnet. All Rights Reserved.
"Access the management page" on page 9).
"Access the management page" on page 9).

Additional hardware installation

Ground wire

When placing your device out in an open area where lightning strikes can occur, it is
advisable to ground it. This would protect your device from being damage and your
network.
1. Loosen and remove the metal O-Ring connected below the optional external N-
Type antenna connecter
2. Place the grounding wire into the connecter and tighten the O-Ring
3. Connect the end of the grounding wire to a grounding area. e.g Earth driven rod of
grounded system.
TEW-715APO
48