Change Your Login Password - TRENDnet TEW-715APO User Manual

TRENDnet User's Guide
• Fragment Threshold: Specify the maximum size in byte for a packet before data is
fragmented into multiple packets. Setting it too low may result in poor network
performance. Leave it at its default of 2346 is recommended.
• Beacon Interval: Specify the frequency interval to broadcast packets. Enter a
value between 20 and 1024.
• DTIM Interval: DTIM, which stands for Delivery Traffic Indication Message, is
contained in the data packets. It is for enhancing the wireless transmission
efficiency. The default is set to 1. Enter a value between 1 and 255.
• Preamble Type: It defines some details on the 802.11 physical layer. "Long" and
"Auto" are available.
• IGMP Snooping: Available in AP/Router mode, IGMP snooping is the process of
listening to IGMP network traffic. By enabling IGMP snooping, the AP will listen to
IGMP membership reports, queries and leave messages to identify the ports that
are members of multicast groups. Multicast traffic will only be forwarded to ports
identified as members of the specific multicast group or groups.
• RIFS: RIFS (Reduced Interframe Spacing) is a means of reducing overhead and
thereby increasing network efficiency.
• Link Integration: Available under AP/Bridge/AP repeater mode, it monitors the
connection on the Ethernet port by checking "Enabled". It can inform the
associating wireless clients as soon as the disconnection occurs.
• TDM Coordination: Stands for "Time-Division Multiplexing Technique", this
resource reservation control mechanisms can avoid packet collisions and send
the packets much more efficiently allowing for higher effective throughput rates.
This function is only available in AP/CPE mode. It is highly recommended to
enable TDM coordination when there are multiple CPEs needed to connect to the
AP in your application.
• Space in Meter: To decrease the chances of data retransmission at long distance,
the IEEE 802.11b/g/n Wireless CPE can automatically adjust proper ACK timeout
value by specifying distance of the two nodes.
• Traffic Shaping: Allows the administrator to specify the incoming and outgoing
traffic limit by checking "Enable Traffic Shaping". This is only available in Router
mode.
© Copyright 2012 TRENDnet. All Rights Reserved.
You can set the multiple SSID to a specific VLAN.
• Enable: Select this option to enable 802.1Q VLAN on the enabled multiple SSID.
• Management VLAN: Enter the VLAN ID to set on your network.

Change your login password

Basic Setting > Change Password
1. Log into the management page (see
2. Click on Management, and click on Password Settings. Click Apply to save changes.
• Current Password: Enter the current password of the access point.
• New Password: Enter the new password
• Confirm Password: Re-enter the new password to confirm.
Note: If you change the login password, you will need to access the management page
using the new password instead of the default password "admin".
TEW-715APO
"Access the management page" on page 9).
36