Port Forwarding - TRENDnet TEW-733GR User Manual

TRENDnet User's Guide
5. Click box to enable rule.
6. Next to Name, you can enter another name for the virtual server.
7. Next to IP Address, enter the IP address assigned to the camera. (e.g. 192.168.10.30)
8. The Private Port and Public Port, make sure port number 80 is configured for both
settings.
9. Next to Schedule, select Always to have rule always on.
10. Next to Inbound Filter, select Allow All.
11. To save the changes, click Save Settings.

Port Forwarding

Access > Virtual Server
Port forwarding allows you to define a specific port or a range of ports (used or required
by a specific application) and forward them to a single IP address (a computer or device)
on your network. Using this feature is more secure compared to using DMZ (see
page 33) in which DMZ forwards all ports instead of only specific ports used by an
application. An example would be forwarding a port to an IP camera (TRENDnet IP
cameras default to HTTP TCP port 80 for remote access web requests) on your network
to be able to view it over the Internet.
Since most ISPs constantly change your home IP address, to be able to access the Virtual
Server port(s) from the Internet it is recommended to setup Dynamic DNS service (See
DynDNS section).
1. Log into your router management page (see
on page 22).
2. Click on Access, and click on Virtual Server.
© Copyright 2012 TRENDnet. All Rights Reserved.
DMZ
"Access your router management page"
3. Review the Port Forwarding Rules settings.
• Enabled: Check the box to enable rule.
• Name: Enter a name for the port forwarding rule.
• IP Address: Enter the IP address of the device to forward the port (e.g.
on
192.168.10.101).
Note: You should assign a static IP address to the device or use DHCP
reservation to ensure the IP address of the device does not change.
• Public Port: Enter the port or range or ports used to access the device from the
Internet.
Note: The Public Port can be assigned a different port number than the Private
Port (also known as port redirection), however it is recommended to use the
same port number for both settings. Please refer to the device documentation
to determine which ports and protocols are required.
• Private Port: Enter the port or range or ports required by your device. Refer to
the connecting device's documentation for reference to the network port(s)
required.
• Protocol: Select the protocol required for your device. TCP, UDP, or you can
select Both to choose both TCP & UDP (recommended).
TEW-733GR
35