Setting Time; Advance Wireless Settings - TRENDnet TEW-715APO User Manual

TRENDnet User's Guide

Setting time

System > Time Settings
1. Log into the management page (see
2. Click on System, and click on Time Settings.
Manual configure time settings
1. Manually enter the date and time settings.
2. Next to Time Zone Select, select your time zone from the drop down menu. Click
Apply to save settings.
Time setting using a NTP server
1. Click Enable NTP client update option to obtain date and time settings from a NTP
server.
2. Select one of the below options. Click Apply to save settings.
• NTP Server: Select a NTP server to use.
• Manual IP: Manually enter your NTP server.
2. You can also click Enable NTP client update option to obtain date and time settings
from a NTP server.
© Copyright 2012 TRENDnet. All Rights Reserved.
"Access the management page" on page 9).

Advance wireless settings

Wireless > Advance Settings
This section outlines available management options under the Advance Settings of the
Wireless button.
• A-MPDU/A-MSDU aggregation: The data rate of your AP except wireless client
mode could be enhanced greatly with this option enabled; however, if your
wireless clients don't support A-MPDU/A-MSDU aggregation, it is not
recommended to enable it.
• Short GI: Under 802.11n mode, enable it to obtain better data rate if there is no
negative compatibility issue.
• RTS Threshold: The IEEE 802.11b/g/n Wireless CPE sends RTS (Request to Send)
frames to certain receiving station and negotiates the sending of a data frame.
After receiving an RTS, that STA responds with a CTS (Clear to Send) frame to
acknowledge the right to start transmission. The setting range is 0 to 2346 in
byte. Setting it too low may result in poor network performance. Leave it at its
default of 2346 is recommended.
TEW-715APO
35