TRENDnet TEW-715APO User Manual page 43

N150 wireless outdoor poe access point

Hide thumbs Also See for TEW-715APO:

Table of Contents

TRENDnet User's Guide

3. Select the management mode you would like to use. Click Apply to save settings.

• Normal: Select this mode to activate Telnet, SNMP and FTP

• Secure: Select this mode to activate SSH, HTTPS, and WISE

• Customized: Select this mode to manually choose the management modes

4. If SNMP is one of the management tools you have selected. You will need to complete

the below settings.

• Protocol Version: Select from the pull down menu the SNMP version to use.

• Server Port: Enter the your SNMP server port

• Get Community: Enter the password for the incoming Get and GetNext requests

from the management station

• Set Community: Specify the password for the incoming Set requests from the

management station.

• Trap Destination: Specify the IP address of the station to send the SNMP traps to.

• Trap Community: Specify the password sent with each trap to the manager.

To use SNMP V3, click the option "Configure SNMPv3 User Profile" to display the

configuration settings.

• User Name: Specify a user name for the SNMPv3 administrator or user. Only the

SNMP commands carrying this user name are allowed to access the access point

• Password: Specify a password for the SNMPv3 administrator or user. Only the

SNMP commands carrying this password are allowed to access the access point

• Confirm Password: Input password again to confirm

• Access Type: Select "Read Only" or "Read and Write" accordingly.

• Authentication Protocol: Select an authentication algorithm. SHA authentication

is stronger than MD5 but is slower.

• Privacy Protocol: Specify the encryption method for SNMP communication. None

and DES are available.

None: No encryption is applied.

DES: Data Encryption Standard, it applies a 58-bit key to each 64-bit

block of data.

TEW-715APO

Table of Contents