MiTAC 8050QMA Service Manual page 69

80 50QMA N/B Maintenance
80 50QMA N/B Maintenance
5. Remove the four screws that secure the LCD brackets. (Figure 2-22)
6. Disconnect the cable to free the LCD panel. (Figure 2-23)
Figure 2-22 Remove the four screws Figure 2-23 Free the LCD panel
Reassembly
1. Replace the cable to the LCD panel.
2. Attach the LCD panel's brackets back to LCD panel and secure with four screws.
3. Replace the LCD panel into LCD housing and secure with ten screws.
4. Reconnect one cable to inverter board.
5. Fit the LCD cover and secure with two screws and rubber pads.
6. Replace the LCD assembly, modem card, DDR, CD/DVD-ROM drive, hard disk drive, CPU, keyboard and
battery pack. (Refer to previous section reassembly)
68