MiTAC 8050QMA Service Manual page 59

80
80
4. To remove the existing CPU, loosen the screw by a flat screwdriver, upraise the CPU socket to unlock the CPU.
(Figure 2-6)
Reassembly
1. Carefully, align the arrowhead corner of the CPU with the beveled corner of the socket, then insert CPU pins
into the holes. Tighten the screw by a flat screwdriver to locking the CPU.
2. Connect the fan's power cord to the system board, fit the heatsink upon the CPU, then secure with four spring
screws and two screws.
3. Replace the CPU cover and secure with seven screws.
4. Replace the battery pack. (Refer to section 2.3.1 Reassembly)
50QMA N/B Maintenance
50QMA N/B Maintenance
Figure 2-6 Remove the CPU
58