EUROCOM 5600D Monte Carlo User Manual page 173

Troubleshooting
Problem
The system does not go
into suspend or save to
disk when the battery is
low.
The Infrared device
doesn't work.
7
7 - 22 Operation
No power savings options are enabled. Use one of the Power Management/Power
Options presets.
The drivers (if supplied with the device) are not loaded. Please read the documentation
which comes with any new external device, and make sure you install the driver (if there
is one needed) for it as this will allow you to access any extra functions which come with
your device.
The Infrared settings are not configured correctly. See
Settings for FIR" on page 3 -
The Infrared transceiver is blocked. Make sure nothing is between your system's infrared
transceiver and the destination's transceiver. Infrared transceivers operate on a "Line of
Sight".
Support for IrDA/AskIR/FIR types infrared devices is disabled. The default infrared mode
(FIR) is backward compatible in supporting IrDA/AskIR devices. This will usually not need
to be changed, however some devices may require specific settings. Changes may be
made in the BIOS Setup in the Advanced menu (see
(Advanced Menu)" on page 5 -
Possible Solution
"Configuring the Infrared
26.
"I/O Device Configuration
11).